Right Exhaust Manifold, Removing And Installing, DSG Transmission 0B5: Installing

WARNING: This page is about a different car, the 2012 Audi Q5 and 2011 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the seals and self-locking nuts.

-- Position the exhaust manifold with the catalytic converter seal and tighten the nuts Figure.

Fig 1: Right Exhaust Manifold Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Install the right engine mount, refer to RIGHT ENGINE MOUNT, REMOVING AND INSTALLING .

-- Install the air filter housing, refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Install the right catalytic converter, refer to RIGHT CATALYTIC CONVERTER, REMOVING AND INSTALLING, DSG TRANSMISSION 0B5 .

-- Install the Heated Oxygen Sensor -G39-, refer to Heated Oxygen Sensor -G39-, REMOVING AND INSTALLING, FRONT OF BANK 1 RIGHT CATALYTIC CONVERTER .

-- Install the noise insulations, refer to OVERVIEW - NOISE INSULATION .