Right Catalytic Converter, Removing And Installing, With Automatic Transmission 0B6: Removing

WARNING: This page is about a different car, the 2012 Audi Q5 and 2011 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Oxygen Sensors - Cylinder Bank 1 (Right)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Oxygen Sensor after Three Way Catalytic Converter -G130- -2-, refer to Oxygen Sensor after Three Way Catalytic Converter -G130- REMOVING AND INSTALLING, BANK 1, RIGHT .

-- Remove the right front muffler, refer to FRONT MUFFLER, REMOVING AND INSTALLING .

-- Remove the bolt -2-, press the retaining tab off the transmission and tilt it back -arrow-.

Fig 2: Removing Retaining Tab Off Transmission -Arrow-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore item -1-.

-- Remove the nuts -arrows- and remove the right catalytic converter downward.

Fig 3: Identifying Right Catalytic Converter Fasteners

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore item -1-.