Right Catalytic Converter, Removing And Installing, DSG Transmission 0B5: Removing

WARNING: This page is about a different car, the 2012 Audi Q5 and 2011 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Strut Tower Brace And Fasteners

Courtesy of AUDI OF AMERICA, LLC

-- Remove the tower brace, refer to TOWER BRACE, REMOVING AND INSTALLING .

-- Remove the Oxygen Sensor after Three Way Catalytic Converter -G130- -2-, refer to Oxygen Sensor after Three Way Catalytic Converter -G130- REMOVING AND INSTALLING, BANK 1, RIGHT .

Fig 2: Locating Oxygen Sensors - Cylinder Bank 1 (Right)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the plenum chamber bulkhead, refer to OVERVIEW - BULKHEAD .

-- Remove the right front muffler, refer to FRONT MUFFLER, REMOVING AND INSTALLING .

-- Remove the right front wheel.

-- Remove the bolt -2-, press the retaining tab off the transmission and tilt it back -arrow-.

Fig 3: Removing Retaining Tab Off Transmission -Arrow-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -item 1-.

-- Remove the nuts -arrows- and the right catalytic converter upward.

Fig 4: Identifying Right Catalytic Converter Fasteners

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -item 1-.