LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 673 (3.2L - Exhaust System & Emission Controls - Engine Code(S): CALB) >> 26 Exhaust System, Emission Controls >> Emissions Control >> Catalytic Converter, Removing And Installing >> Right Catalytic Converter, Removing And Installing, DSG Transmission 0B5 >> Installing

Right Catalytic Converter, Removing And Installing, DSG Transmission 0B5: Installing

WARNING: This page is about a different car, the 2012 Audi Q5 and 2011 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the seals and self-locking nuts.

-- Install the front wheel, wheel bolts, Tightening Specification: 140 Nm .

-- Install the right front muffler, refer to FRONT MUFFLER, REMOVING AND INSTALLING .

-- Install the plenum chamber bulkhead, refer to OVERVIEW - BULKHEAD .

-- Install the Oxygen Sensor after Three Way Catalytic Converter -G130-, refer to Oxygen Sensor after Three Way Catalytic Converter -G130- REMOVING AND INSTALLING, BANK 1, RIGHT .

-- Install the tower brace, refer to TOWER BRACE, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals