Left Catalytic Converter, Removing And Installing, With Automatic Transmission 0B6: Removing

Fig 1: Identifying Strut Tower Brace And Fasteners

Courtesy of AUDI OF AMERICA, LLC

-- Remove the tower brace, refer to TOWER BRACE, REMOVING AND INSTALLING .

-- Remove the Oxygen Sensor 2 after Catalytic Converter -G131- -2-, refer to Oxygen Sensor 2 after Catalytic Converter -G131-, REMOVING AND INSTALLING, BANK 2, LEFT .

Fig 2: Identifying Oxygen Sensors Location, Cylinder Bank 2 (Left)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the plenum chamber bulkhead, refer to OVERVIEW - BULKHEAD .

-- Remove the left front muffler, refer to FRONT MUFFLER, REMOVING AND INSTALLING .

-- Remove the left front wheel.

-- Remove the drive axle cover -1- in the left wheel housing.

Fig 3: Driveshaft Cover -1-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and the left drive axle heat shield.

Fig 4: Identifying Left Drive Axle Heat Shield Fasteners

Courtesy of AUDI OF AMERICA, LLC

-- Remove the ball socket -1- on the selector lever cable from the selector shaft lever using the Pry Lever 80-200.

Fig 5: Selector Lever Cable, Ball Socket And Securing Clips

Courtesy of AUDI OF AMERICA, LLC

-- Press the securing clips -2- off and remove the selector lever cable from the transmission.

-- Remove the nuts -arrows- and bolt -1- and remove the left catalytic converter from the exhaust manifold.

Fig 6: Identifying Left Catalytic Converter Fasteners

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1- and the bracket.

Fig 7: Removing Bolts And Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Remove the left catalytic converter from the top.