Transmission Output Shaft Seal With Splines, Removing - Vehicles With Vibration Damper On The Transmission Output Shaft: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 Audi S5, 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, and 2009 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the center differential housing. Refer to CENTER DIFFERENTIAL HOUSING AND CENTER DIFFERENTIAL WITH TRANSMISSION INSTALLED .

Fig 1: Removing/Installing Circlip On Inner Side Of Cover

Courtesy of AUDI OF AMERICA, LLC

-- Remove the circlip -arrow- on the inside of the housing.

NOTE:

The circlip secures the transmission output shaft to the bearing in the housing.

-- Carefully remove the transmission output shaft from the center differential housing using a copper mandrel.

NOTE:

To remove the transmission output shaft, secure the center differential housing in a vise or have a 2nd technician hold it tight.

-- Pry out the shaft seal -1-.

Fig 2: Prying Out Shaft Seal -1-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -2-.