Right Seal, Replacing

WARNING: This page is about a different car, the 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Used Oil Collection and Extraction Unit SMN372500
Puller - Seal Lever VW681
Seal Installer - Flange Seal T40189

Procedure

NOTE:

Clean working conditions for the automatic transmission, refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

General repair instructions, refer to GENERAL REPAIR INFORMATION .

-- Place the Used Oil Collection and Extraction Unit SMN372500 under the transmission.

-- Remove the right flange shaft, refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING .

-- Remove the right flange shaft seal.

Fig 1: Flange Shaft Oil Seal, Removal

Courtesy of AUDI OF AMERICA, LLC

-- Coat the outer circumference of the new shaft seal with axle oil.

Installed position: The open side of the shaft seal faces the transmission.

-- Drive on in new shaft seal as far as stop. When doing this, do not bend the shaft seal or install it on an angle.

Fig 2: Identifying New Shaft Seal, Installation

Courtesy of AUDI OF AMERICA, LLC

-- Install the right flange shaft, refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING .

-- Add axle oil to the transmission after repair, refer to GEAR OIL, DRAINING AND FILLING, FRONT FINAL DRIVE .