Transmission Output Shaft Ball Bearing, Replacing: Installing

WARNING: This page is about a different car, the 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

-- Install the transmission output shaft ball bearing.

Fig 1: Flange Shaft Ball Bearing, Installation

Courtesy of AUDI OF AMERICA, LLC

The shoulder on the Press Piece - 60mm VW415A -arrow- faces the Press Piece - Multiple Use VW412.

-- Install the ball bearing locking ring -B-.

Fig 2: Identifying Installation Position Of Circlips

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -A-.

-- Install the transmission output shaft seal and the transmission output shaft with splines into the center differential housing, refer to TRANSMISSION OUTPUT SHAFT, REMOVING AND INSTALLING .

-- Install the center differential housing, refer to CENTER DIFFERENTIAL, REMOVING AND INSTALLING .

-- Fill gear oil in transfer case, refer to GEAR OIL, DRAINING AND FILLING, TRANSFER CASE .