Removing And Installing

WARNING: This page is about a different car, the 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Center Differential -1- At Input Shaft

Courtesy of AUDI OF AMERICA, LLC

-- Remove the center differential housing, refer to CENTER DIFFERENTIAL, REMOVING AND INSTALLING .

-- Remove the center differential -1- from the input shaft.

-- Removing the ball bearing from the center differential

Fig 2: Removing Ball Bearing From Center Differential

Courtesy of AUDI OF AMERICA, LLC

A - Puller - Kukko Quick Action Separating Tool - 22-115mm 17/2

The Press Piece - Bushing - 50mm Diameter VW432 faces the ball bearing.

-- Installing the ball bearing onto the center differential

Fig 3: Ball Bearing Installed Onto Center Differential

Courtesy of AUDI OF AMERICA, LLC