Oil Pan Upper Section, Removing And Installing: Removing
WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- The engine is removed and secured to the engine/transmission holder, refer to ENGINE, SECURING ON ENGINE AND TRANSMISSION HOLDER .
- Engine oil is drained, refer to ENGINE OIL, DRAINING/EXTRACTING; OIL FILTER, REPLACING .
-- Remove the timing chain cover lower section, refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .
-- Remove the oil pump drive chain and the high pressure pump, refer to OIL PUMP AND HIGH PRESSURE PUMP DRIVE CHAIN, REMOVING AND INSTALLING .
-- Remove the belt pulley side sealing flange, refer to SEALING FLANGE, BELT PULLEY SIDE, REMOVING AND INSTALLING .
-- Remove the oil pump, refer to OIL PUMP, REMOVING AND INSTALLING .
-- Disconnect the connector -1- from the Oil Pressure Regulation Valve -N428-.
NOTE:
Ignore item -2-.
-- Loosen and remove the bolts in the following sequence: -12 to 1-.
-- Loosen the oil pan upper section carefully from the adhesive then push it off the alignment sleeves and remove it.