Valve Guides, Checking

WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Dial Gauge Holder VW387
Dial Gauge - 0-10mm VAS6079

Procedure

Fig 1: Identifying Dial Gauge With Holder

Courtesy of AUDI OF AMERICA, LLC

NOTE:

If valve is replaced during repair, use new valve for measurement.

Due to different stem diameters, only use an intake valve in the intake valve guide and an exhaust valve in the exhaust valve guide.

-- Place valve in valve guide.

Valve stem tip must seal with valve guide.

-- Determine tip clearance.

Wear limit: 1.0 mm.

-- If wear limit is exceeded, measure using new valves.

-- Replace the cylinder head if the wear limit is still exceeded.

NOTE:

The valve guides cannot be replaced.