Brake Lamp Switch, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
- The brake push rod must be engaged with the brake pedal.
- When installing switch, brake pedal must not be operated.
-- Insert the Brake Lamp Switch -F- into the mount -1- on the brake pedal.
- The Brake Lamp Switch -F- must audibly engage with all three tabs.
- Do not turn the Brake Lamp Switch -F- once it is inside the mount on the brake pedal.
- The piston aligns itself automatically when inserting.
-- To attach the brake lamp switch, turn the rotating piece -2- clockwise until it stops -arrows-.
Installation is performed in reverse order of removal, while noting the following:
-- Remove the footwell vent, refer to DRIVER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .
-- Install the footwell vent, refer to DRIVER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .
Install the driver side instrument panel cover, refer to INSTRUMENT PANEL SIDE COVER, REMOVING AND INSTALLING .
WARNING:
Before the first drive, check and ensure that the brake lamp switch functions are correct.