Fuel Pump Control Module -J538-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and remove the key.

-- Remove 1/3 of the rear seat, refer to SEAT BENCH/SINGLE SEAT, REMOVING AND INSTALLING .

-- Remove the bolts -arrows- and remove the sealing flange cover -1-.

Fig 1: Identifying Locking Flange Cover & Bolts -Arrows-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and remove the Fuel Pump Control Module -J538-.

-- Press the locking ring at the installation opening for the fuel tank down slightly if necessary to do this.

-- Disconnect the connector -6-.

Fig 2: Installation Location Fuel Pump Control Module -J538-

Courtesy of AUDI OF AMERICA, LLC