Inner CV Joint, Checking: Disassembling

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Ball hub and joint are paired and should be identified before removal. Do not interchange cage allocation.

-- Swivel the ball hub and ball bearing cage.

Fig 1: Removing Joint In Direction Of -Arrow-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the joint in the direction of the -arrow-.

-- Remove the balls from the cage.

-- Flip out ball hub from ball cage via running path of ball -arrows-.

Fig 2: Flipping Out Ball Hub From Ball Cage Via Running Path Of Ball

Courtesy of AUDI OF AMERICA, LLC

-- Check joint piece, ball hub, ball cage and balls for small broken off depressions (pitting build-up) and chafing.

NOTE:

Excessive backlash in joint will be noticed as a knock during load changes. Joint must be replaced in such cases. Flattening and running marks of balls are no reason to replace joint.