Wiring Harness In Transmission: Installing
WARNING: This page is about a different car, the 2010 Audi A5, 2009 Audi A5, and 2008 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order, paying attention to the following:
-- Replace wiring harness connector O-rings and lightly coat with ATF.
-- Insert the wiring harness connector into the transmission housing while following the installation position.
-- Install the clip -A- on the wiring harness connector -B-.
-- Install Mechatronic unit. Refer to MECHATRONIC UNIT .