Brake Shield, Removing And Installing, Vehicles With Fwd: Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Position the brake shield.

-- Install the bolts on the brake shield and tighten them.

-- Install the wheel bearing housing, refer to WHEEL BEARING HOUSING, REMOVING AND INSTALLING, FWD VEHICLES .

-- Install the rear brake rotor, refer to BRAKE ROTOR, REMOVING AND INSTALLING .

-- Install the brake hose and electrical wire into the bracket on the stub axle carrier.

NOTE:

Make sure the brake hose and wiring is correctly attached and secured inside the bracket on the stub axle carrier. This will prevent the hose and wiring from coming out of the bracket.

WARNING:

There is the risk of an accident.

Before moving the vehicle, press the brake pedal firmly several times to seat the brake pads correctly in their operating position.
Make sure the brakes are working correctly before driving the vehicle.