LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 658 (Brake System - Mechanical Components) >> 46 Mechanical Components >> Parking Brake >> Left/Right Parking Brake Motor -V282- / -V283-, Removing And Installing >> Installing

Left/Right Parking Brake Motor -V282- / -V283-, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Install new seal.

-- Turn the brake caliper adjuster screw -1- back slightly.

Fig 1: Positioning Actuator
GWWA46-0324Courtesy of AUDI OF AMERICA, LLC
NOTE:

This makes it easier to install the actuator.

-- Position the actuator.

NOTE:

Make sure that the seal is seated correctly

-- Item -2- Then rotate actuator so bolt hole -a- and threads in brake caliper housing -b- are brought into alignment.

Fig 2: Rotate Actuator So Bolt Hole And Threads In Brake Caliper Housing Are Brought Into Alignment
GWWA46-10033Courtesy of AUDI OF AMERICA, LLC

Make sure that parking brake actuator is seated flush against the brake caliper.

-- Attach both actuator bolts (Torx 30).

Fig 3: Attaching Both Actuator Bolts
GWWA46-10034Courtesy of AUDI OF AMERICA, LLC

Position the motor bolts by hand and screw in a few turns. If threads are damaged, entire brake caliper must be replaced!

-- Tighten the motor bolts. Tightening specification 12 Nm.

-- Connect the connector to the motor.

NOTE:

Only insert connector by hand to avoid damaging it.

Make sure that connectors on vehicle side and actuator side are free of dirt and damage.

-- Install the motor in the bracket.

-- Install the rear wheel, refer to WHEEL, CHANGING AND MOUNTING .

-- Connect the Vehicle diagnostic tester to the diagnostic connection on the vehicle with the ignition switched off.

Fig 4: Identifying DLC Terminals
GWWA97-11532Courtesy of AUDI OF AMERICA, LLC

-- Turn on the ignition.

-- After entering the VIN, select Guided Functions  .

-- Basic Setting, Performing

Vehicle Diagnostic Tester Display 

Suspension/brake system
  01_OBD-capable systems
    53 Electromechanical parking brake control module J540
      53 Electrical parking brake functions
        53 46 Basic setting

-- Continue to follow the instructions in the vehicle diagnostic tester display.