Electromechanical Parking Brake Control Module -J540-, REMOVING AND INSTALLING: Notes
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Torque Wrench 1410 VAG1410
CAUTION:
The Electromechanical Parking Brake Control Module -J540- mounting direction must not be reversed due to the internal tilt angle sensor. The Module must also be mounted flat.
NOTE:
If the control module is replaced, select the "Replace function" in "Guided Functions " on the control module, refer to Vehicle Diagnostic Tester.