Electromechanical Parking Brake Control Module -J540-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Insert and screw in the control module in a horizontal position.

Tightening specification, refer to OVERVIEW - PARKING BRAKE .

-- Connect the connector -2- to the control module -1-.

Fig 1: Connecting Electrical Connectors On Control Module

Courtesy of AUDI OF AMERICA, LLC

-- Slide the retainer on the connector back and lock it.

-- Insert the control module.

-- Install nuts.

Install the trailer mode control module and bracket, if applicable.

-- Install the Towing Recognition Control Module --.

NOTE:

Insert and install the control module in a horizontal position.

-- If the control module is replaced, select the "Replace" function in "Guided Functions " on the control module, refer to Vehicle Diagnostic Tester.