Brake Rotor, Brake 1LB/1LC/1LE/1LP, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specifications, refer to OVERVIEW - FRONT BRAKES, 1LB, 1LC, 1LE AND 1LP .

-- Clean the contact surfaces on the wheel hub and brake rotor. Remove any corrosion.

-- Place the brake rotor on the hub.

NOTE:

When positioning the brake rotor, do not tilt it on the wheel hub.

-- Install the bolt -5- and tighten.

-- Install the brake caliper, refer to BRAKE CALIPER, BRAKE 1LB/1LC/1LE/1LP, REMOVING AND INSTALLING .

WARNING:

There is the risk of an accident.

Before moving the vehicle, press the brake pedal firmly several times to seat the brake pads correctly in their operating position.
Make sure the brakes are working correctly before driving the vehicle.