Brake Pads, Removing And Installing, Brake 1LE And 1LP: Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

If old brake pads are being replaced with new ones, then it is necessary to check the brake rotor for wear. Pay attention to the brake rotor wear limit while doing this.

-- Check brake rotor, refer to FRONT BRAKES .

Tightening specifications, refer to OVERVIEW - FRONT BRAKES, 1LB, 1LC, 1LE AND 1LP .

NOTE:

Always replace brake pads on the same axle at the same time.

Install complete repair kit .

Install on one axle on brake pads from the same manufacturer and with the same quality.

Use only mineral spirits or commercially available brake cleaner to clean the brake caliper.

-- Clean brake caliper.

-- Remove any protective film from the brake pad backing plate.

-- Insert brake pads in brake caliper.

NOTE:

The brake pad and brake pad wear wire face the inside.

-- Insert the brake pad spring -8-.

Fig 1: View Of Brake Pad Spring And Pad Pins

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Make sure the brake pad spring is installed correctly.

-- Push the brake pad spring -7- from the inside toward the outside through the hole in the brake caliper. Press the brake pad pin all the way, if necessary.

CAUTION:

The brake pad pin needs to be seated securely in both holes so that it doesn't loosen on its own.

NOTE:

The brake pad spring -8- is located under the brake pad pin -7-. The spring on the end of the brake pad pin secure the brake pad pin inside the brake caliper.

Be careful not to scratch or damaged the coating on the brake caliper.

-- Push the second brake pad pin from the inside toward the outside through the hole in the brake caliper. Push the brake pad spring downward at the same time. Press the brake pad pin all the way, if necessary.

Fig 2: View Of Brake Pad Spring And Pad Pins

Courtesy of AUDI OF AMERICA, LLC

Press the brake pad spring -8- inward for support.

NOTE:

The brake pad spring -8- is located under the brake pad pin -7-. The spring on the end of the brake pad pin secure the brake pad pin inside the brake caliper.

Be careful not to scratch or damaged the coating on the brake caliper.

-- Connect the brake pad wear wire.

-- Attach the brake pad wear wire.

-- Mount the wheels, refer to WHEEL, CHANGING AND MOUNTING .

-- Check the brake fluid level and fill if necessary.

WARNING:

There is the risk of an accident.

Before moving the vehicle, press the brake pedal firmly several times to seat the brake pads correctly in their operating position.
Make sure the brakes are working correctly before driving the vehicle.