Brake Caliper, Removing And Installing, Brake 1LV And 1ZK, Sq5: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove affected front wheel, refer to WHEEL, CHANGING AND MOUNTING .

-- Disconnect the connector for the brake pad wear display -arrow-.

Fig 1: Disconnecting Brake Wear Indicator Connector

GWWA46-0253

Courtesy of AUDI OF AMERICA, LLC

-- Release the connector from the mount while turning it 90° at the same time.

Fig 2: Releasing Connector From Mount

GWWA46-0252

Courtesy of AUDI OF AMERICA, LLC

-- Remove the connector from the bracket.

Fig 3: Unhooking Brake Line From Retainer

GWWA46-0254

Courtesy of AUDI OF AMERICA, LLC

-- Unhook brake line from retainer

Fig 4: Overview Of Front Brakes (1LV, 1ZK, And SQ5)

GWWA46-10147

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -13-.

NOTE:

Pushing the brake pads slightly back with pliers makes it easier to remove the brake caliper from the brake rotor. To avoid damaging the brake caliper, place a piece of rubber or similar material -2- between the brake caliper. Do not damage the existing brake pad wear indicator cable when doing this.

Fig 5: Pushing Brake Pads Slightly Back From Rotor With Pliers

GWWA46-10342

Courtesy of AUDI OF AMERICA, LLC

-- Remove the brake caliper -7- from the brake carrier -12-.

CAUTION:

Do not let the brake caliper with the brake carrier hang on the brake hose. Do not support the weight with the brake hose.
Replace the brake hose if damaged.
Do not press the brake pedal when the caliper is removed.