Brake Caliper, Removing And Installing, Brake 1LV And 1ZK, Sq5: Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specifications, refer to OVERVIEW - FRONT BRAKES, 1LV AND 1ZK, SQ5 .

NOTE:

Replace bolts, allocate correct bolts.

Use only mineral spirits or commercially available brake cleaner to clean the brake caliper.

-- Push the brake caliper -7- with the brake carrier -12- and the brake pads installed carefully over the brake rotor.

Make sure the brake hose is routed correctly. Make sure the brake hose is not blocked, bent or rubbing against the vehicle.

-- Secure the brake carrier with new bolts -13-.

-- Install the brake line in the bracket.

-- Connect wear indicator connector.

Fig 1: Identifying Contact

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Make sure the contact for the brake pad wear display fits correctly in the clip inside the inner brake pad.

-- Install the electrical connection for the brake pad wear display in the bracket.

-- Mount the wheels, refer to WHEEL, CHANGING AND MOUNTING .

-- Check brake fluid level, and fill if necessary.

WARNING:

There is the risk of an accident.

Before moving the vehicle, press the brake pedal firmly several times to seat the brake pads correctly in their operating position.
Make sure the brakes are working correctly before driving the vehicle.