Brake Caliper, Brake 1LB/1LC/1LE/1LP, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove affected front wheel, refer to WHEEL, CHANGING AND MOUNTING .

-- Unclip the brake hose from the pivot bearing

-- Unclip the brake pad wear wire.

Fig 1: Overview Of Front Brakes (1LB, 1LC, 1LE And 1LP)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1-.

NOTE:

Pushing the brake pads slightly back with pliers makes it easier to remove the brake caliper from the brake rotor. To avoid damaging the brake caliper, place a piece of rubber or similar material -2- between the brake caliper. Do not damage the existing brake pad wear indicator cable when doing this.

Fig 2: Pushing Brake Pads Slightly Back From Rotor With Pliers

Courtesy of AUDI OF AMERICA, LLC

-- Carefully remove the brake caliper with the brake pads still installed.

NOTE:

Do not disassemble the brake caliper. Do not loosen any screws on the brake caliper.

CAUTION:

Do not let the brake caliper with the brake carrier hang on the brake hose. Do not support the weight with the brake hose.
Replace the brake hose if damaged.
Do not press the brake pedal when the caliper is removed.