Brake Caliper, Brake 1LB/1LC/1LE/1LP, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specifications, refer to OVERVIEW - FRONT BRAKES, 1LB, 1LC, 1LE AND 1LP .

NOTE:

Use new bolts, allocate correct bolts.

Use only mineral spirits or commercially available brake cleaner to clean the brake caliper.

-- Clean brake caliper.

-- Carefully press the brake caliper with the brake carrier and the installed brake pads over the brake rotor.

-- Tighten the brake caliper with the new bolts.

-- Install the brake hose into the bracket on the pivot bearing.

-- Attach the brake pad wear wire.

-- Mount the wheels, refer to WHEEL, CHANGING AND MOUNTING .

-- Check brake fluid level, and fill if necessary.

WARNING:

There is the risk of an accident.

Before moving the vehicle, press the brake pedal firmly several times to seat the brake pads correctly in their operating position.
Make sure the brakes are working correctly before driving the vehicle.