Exhaust Gas Temperature Sensor 3 -G495-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

When working on the whole exhaust system:

Follow the safety precautions when working on the exhaust system, refer to EXHAUST SYSTEM SAFETY PRECAUTIONS .

NOTE:

When installing, bring all cable ties back to same positions.

When removing the wire do not cut it, in this case a fault diagnosis will no longer be possible.

-- Remove the engine cover, refer to ENGINE COVER, REMOVING AND INSTALLING .

Exhaust Gas Temperature Sensor 3 -G495- Version 1:

Fig 1: Exhaust Gas Temperature Sensor 3 -G495- Version 1

Courtesy of AUDI OF AMERICA, LLC

-- Remove the connector -1- from the bracket and disconnect it.

-- Remove the Exhaust Gas Temperature Sensor 3 -G495- -2- with a tool from the Diesel Engine Tool Set - 17mm T10395 A.

Exhaust Gas Temperature Sensor 3 -G495- Version 2:

Fig 2: Exhaust Gas Temperature Sensor 3 -G495- Version 2

Courtesy of AUDI OF AMERICA, LLC

-- Remove the connector -3- from the bracket and disconnect it.

-- Remove the Exhaust Gas Temperature Sensor 3 -G495- -1- with a tool from the Diesel Engine Tool Set - 17mm T10395 A.

NOTE:

Vehicles where bracket -5- is installed, remove nut -4- and remove the bracket.

Route the lines, as show in the illustration.

Connect cable tie -2- as show in the illustration.