Exhaust Gas Temperature Sensor 3 -G495-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
- Tightening specification, refer to OVERVIEW - EXHAUST TEMPERATURE REGULATION .
NOTE:
Protect the exhaust gas temperature sensor against knocks and impacts. A dropped exhaust gas temperature sensor may not be used again.
Coat the thread with hot bolt paste .
Exhaust Gas Temperature Sensor 3 -G495- Version 2:
NOTE:
Vehicles where bracket -5- is installed, remove nut -4- and remove the bracket.
Route the lines, as show in the illustration.
Connect cable tie -2- as show in the illustration.