Exhaust Gas Temperature Sensor 3 -G495-, REMOVING AND INSTALLING, VEHICLE WITH ENGINE CODE CGQB: Removing

WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Differential Pressure Sensor - G505- Component Location

Courtesy of AUDI OF AMERICA, LLC

NOTE:

When removing the wire do not cut it, in this case a fault diagnosis will no longer be possible.

-- Remove the front exhaust pipe, refer to FRONT EXHAUST PIPE, REMOVING AND INSTALLING, VEHICLES WITH ENGINE CODE CGQB .

-- Remove the connector -2- from the bracket, disconnect it and free up the wire.

-- Remove the Exhaust Gas Temperature Sensor 3 -G495- -item 1-.