Exhaust Gas Temperature Sensor 2 -G448-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
When working on the whole exhaust system:
- Follow the safety precautions when working on the exhaust system, refer to EXHAUST SYSTEM SAFETY PRECAUTIONS .
NOTE:
When installing, bring all cable ties back to same positions.
When removing the wire do not cut it, in this case a fault diagnosis will no longer be possible.
-- Remove the engine cover, refer to ENGINE COVER, REMOVING AND INSTALLING .
Exhaust Gas Temperature Sensor 2 -G448- :
-- Remove the connector -2- from the bracket and disconnect it.
-- Free up the wire.
-- Remove the Exhaust Gas Temperature Sensor 2 -G448- -1- with a tool from the Diesel Engine Tool Set - 17mm T10395 A.