Exhaust Gas Temperature Sensor 1 -G235-, REMOVING AND INSTALLING, VEHICLE WITH ENGINE CODE CGQB: Removing

WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exhaust Gas Temperature Sensors In The Turbocharger

Courtesy of AUDI OF AMERICA, LLC

NOTE:

When installing, bring all cable ties back to same positions.

When removing the wire do not cut it, in this case a fault diagnosis will no longer be possible.

-- Remove the catalytic converter, refer to CATALYTIC CONVERTER, REMOVING AND INSTALLING .

-- Remove the connector -2- from the bracket, disconnect it and free up the wire.

-- Remove the Exhaust Gas Temperature Sensor 1 -G235- -item 1- with a tool from the Diesel Engine Tool Set - 17mm T10395 A.