LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 657 (3.0L - Exhaust System & Emission Controls - Engine Code(S): CPNB) >> 26 Exhaust System, Emission Controls >> Exhaust Manifold >> Exhaust Manifold, Removing And Installing >> Right Exhaust Manifold, Removing And Installing >> Tightening Specifications

Tightening Specifications

WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Replace the seals and self-locking nuts.

-- Tighten the exhaust manifold nuts, refer to Figure.

-- Install the air guide pipe, refer to OVERVIEW - CHARGE AIR SYSTEM .

-- Install the air guide hoses and screw-type clamps, refer to Figure.

Fig 1: Air Hose Clamp Identification
GWWA21-10396Courtesy of AUDI OF AMERICA, LLC

-- Install the front noise insulation, refer to OVERVIEW - NOISE INSULATION .

-- Install the air filter housing, refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Install the particulate filter, refer to PARTICULATE FILTER, REMOVING AND INSTALLING .