EGR Temperature Sensor -G98-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover, refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove the Intake Flap Motor -V157-, refer to Intake Flap Motor -V157-, REMOVING AND INSTALLING .

-- Disconnect the connector -1-.

Fig 1: Connector At The Throttle Valve Control Module, Screw Clamp & Air Guide Hose

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamp -3- and remove the Throttle Valve Control Module -J338- with the air guide pipe.

-- Remove the bolts -arrows- and then press the bracket -2- and the EGR Cooler Switch-Over Valve -N345- to the side.

Fig 2: Locating Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the connector -1- from the bracket, disconnect it and free up the wire.

Fig 3: Locating Connector

Courtesy of AUDI OF AMERICA, LLC

-- Remove the EGR Temperature Sensor -G98- -2-.