Overview - Emissions Control
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Nut
- Tightening Specification: 40 Nm
- Replacing
- Coat turbocharger stud bolts with hot bolt paste.
- Seal
- Replacing
- Turbocharger
- Heated Oxygen Sensor -G39- and Oxygen Sensor Heater -Z19-
- Removing and installing, refer to Heated Oxygen Sensor -G39-, REMOVING AND INSTALLING, NON-HYBRID VEHICLES .
- Oxygen Sensor after Three Way Catalytic Converter -G130- and Heater for Oxygen Sensor 1 after Catalytic Converter -Z29-
- Removing and installing, refer to Oxygen Sensor after Three Way Catalytic Converter - G130-, REMOVING AND INSTALLING, NON-HYBRID VEHICLES .
- Catalytic Converter
- Protect catalytic converter from shocks and impact stress
- Removing and installing, refer to CATALYTIC CONVERTER, REMOVING AND INSTALLING, NON-HYBRID VEHICLES .
- Align the exhaust system free of tension, refer to EXHAUST SYSTEM, ALIGNING FREE OF TENSION, NON HYBRID VEHICLES .
- Nut
- Tightening Specification: 25 Nm
- Replacing
- Seal
- Replacing
- Front Muffler
- Nut
- Spacer Sleeve
- Tab
- Pressure Spring
- Washer
- Bolt - Tightening Specification: 23 Nm
- Bolt - Tightening Specification: 23 Nm
- Spacer Sleeve
- Adjusting Buffer
- Bolt - Tightening Specification: 23 Nm
- Bracket
NOTE:
The illustration shows a vehicle with a S tronic transmission.