LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 656 (2.0L - Exhaust System & Emission Controls - Engine Code(S): CAEB, CHJA, CPMA & CPMB) >> 26 Exhaust System, Emission Controls >> Emissions Control >> Exhaust Door Control Unit -J883-, REMOVING AND INSTALLING >> Removing

Exhaust Door Control Unit -J883-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Bumper Cover -1- And Bolts
GWWA26-11383Courtesy of AUDI OF AMERICA, LLC
NOTE:

The installation and the removal for the left exhaust door control unit is described.

-- Remove the bolts -arrows- and pull the rear bumper cover -1- slightly downward.

-- Disconnect the connector -4-.

Fig 2: Exhaust Door Control Unit -J883- - Tightening Specification
GWWA26-11321Courtesy of AUDI OF AMERICA, LLC

-- Lower the exhaust system rear section -1-.

-- Tighten the nuts -3- and remove the exhaust door control unit -2-.