Overview - Fuel Delivery Unit/Fuel Level Sensor, Vehicles Through My 2012
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
- Fuel Delivery Unit
- With the fuel filter in the sealing flange
- Fuel pump, electrical testing, refer to Transfer Fuel Pump -G6-, CHECKING .
- Removing and installing, refer to FUEL DELIVERY UNIT/FUEL LEVEL SENSOR, REMOVING AND INSTALLING .
- Fuel filter, removing and installing, refer to FUEL FILTER, REMOVING AND INSTALLING .
- Fill the fuel tank with at least five liters of fuel after installing
- Fuel Line
- To the engine
- Do not kink
- Press the release button to remove from the sealing flange
- Clipped to the fuel tank
- Seal
- Replace
- Install dry
- Locking Ring
- Tighten to 110 Nm
- Remove and install with the Wrench - Fuel Sending Unit T10202
- Fuel Line
- To the metering pump on vehicles with an auxiliary heater
- Do not kink
- Press the release button to remove from the sealing flange
- Clipped to the fuel tank
- Connector
- For the Transfer Fuel Pump -G6- and the Fuel Level Sensor -G-
- Connector
- For the Fuel Pump Control Module -J538-
- Bolt
- 2.5 Nm
- Fuel Pump Control Module -J538-
- Removing and installing, refer to Fuel Pump Control Module -J538-, REMOVING AND INSTALLING .
- Fuel Level Sensor -G-
- For checking the resistance values, refer to Fuel Level Sensor -G-, CHECKING .
- Removing and installing, refer to Fuel Level Sensor -G-, REMOVING AND INSTALLING .
- Suction Jet Pump
- Suction Jet Pipe
- To disconnect, press release button on the connection piece.