Overview - EVAP System, AUDI Q5 Hybrid, Not For USA Vehicles
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
- Vent Line
- To the left rear air filter under the wheel housing liner
- Removing and installing EVAP CANISTER, REMOVING AND INSTALLING, AUDI Q5 HYBRID, NOT FOR USA VEHICLES .
- Honeycomb Filter 1
- Removing and installing HONEYCOMB FILTER 1, REMOVING AND INSTALLING, AUDI Q5 HYBRID, NOT FOR USA VEHICLES .
- Seal
- Insert into the EVAP canister
- Bolt
- Quantity: 2
- 2.8 Nm
- EVAP Canister
- Component location: on the underbody under the rear left floor panel
- Removing and installing EVAP CANISTER, REMOVING AND INSTALLING, AUDI Q5 HYBRID, NOT FOR USA VEHICLES .
- Bolt
- Quantity: 3
- 16 Nm
- Rubber Grommet
- Quantity: 3
- Insert into the EVAP canister
- Bushing
- Quantity: 3
- Insert into the rubber grommet
- Bracket
- For the EVAP canister
- Vent line/air filter
- Installed location: under the wheel housing liner in left rear wheel housing
- Removing and installing EVAP CANISTER, REMOVING AND INSTALLING, AUDI Q5 HYBRID, NOT FOR USA VEHICLES .
- Clipped to the bracket
- Nut
- 5 Nm
- Breather line
- From the fuel tank
- To disconnect, press release button on the connection piece.
- Breather line
- to EVAP Canister Purge Regulator Valve 1 -N80-
- To disconnect, press release button on the connection piece.
- Clipped to the bracket
- Bolt
- Quantity: 4
- 1.5 Nm
- Bracket
- For the honeycomb filter
- Removing and installing HONEYCOMB FILTER BRACKET, REMOVING AND INSTALLING, AUDI Q5 HYBRID, NOT FOR USA VEHICLES .
- Hose
- Honeycomb Filter 2
- Removing and installing HONEYCOMB FILTER 2, REMOVING AND INSTALLING, AUDI Q5 HYBRID, NOT FOR USA VEHICLES .
- Hose clamps
- Must be appropriate for the model type.