Connection Diagram - EVAP System, With Leak Detection System, AUDI Q5 Hybrid
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
- Fuel Tank Leak Detection Control Module -J909-
- Installed location: on the right, front of the fuel tank
- Removing and installing, refer to LEAK DETECTION PUMP, REMOVING AND INSTALLING .
- Connection for the Breather Line on the Fuel Tank
- Fuel Tank Pressure Sensor -G400-
- Installed location: under the wheel housing liner in left rear wheel housing
- Removing and installing, refer to FUEL TANK PRESSURE SENSOR, REMOVING AND INSTALLING .
- Air Filter
- For the leak detection system
- At the top inside the left rear wheel housing
- Removing and installing, refer to LEAK DETECTION SYSTEM AIR FILTER, REMOVING AND INSTALLING .
- EVAP Canister
- Component location: on the underbody under the rear left floor panel
- Removing and installing, refer to EVAP CANISTER, REMOVING AND INSTALLING, AUDI Q5 HYBRID .
- Filter
- EVAP Canister Purge Regulator Valve 1 -N80-