LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 651 (Wiper/Washer Systems) >> 92 Wiper/Washer Systems >> Windshield Wiper System >> Windshield Wiper Motor -V-, REMOVING AND INSTALLING >> Removing

Windshield Wiper Motor -V-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Clips -1- & Remove Plenum Chamber Cover -2-
GWWA92-10145Courtesy of AUDI OF AMERICA, LLC

-- Turn off the ignition and remove the key.

CAUTION:

Damaged high voltage components may produce dangerously high voltage.

Note the following when working near high voltage components and cables:

  • Do not use tools that have sharp edges, that are used for cutting or shaping, or that generate heat, such as welding, soldering, hot air or thermal adhesive equipment.
  • Inspect the high voltage components in the area where the work will be performed before starting the procedure.
  • Visually inspect the Electric Drive Power and Control Electronics -JX1-, the Electro-Drive Drive Motor -V141-, the A/C Compressor -V470- and the high voltage cables when working inside the engine compartment.
  • Perform a visual inspection of the high voltage cables and the covers when working on the floor panel.
  • Perform a visual inspection of the high voltage cables and the electro-box with the High Voltage System Maintenance Connector -TW- when working in the rear of the vehicle.
  • Perform a visual inspection of all of the potential equalization cables.

Note the following when performing the visual inspection:

  • None of the components may display any exterior damage.
  • The high voltage cable insulation and the potential equalization cables may not be damaged.
  • The high voltage cables may not be deformed in any way.
  • Each high voltage component muss be labeled with a red warning label.

-- Remove wiper arms, refer to WINDSHIELD WIPER ARMS, REMOVING AND INSTALLING .

-- Remove the seal -3-.

-- Remove the retaining clips -1- from the mounts and remove the plenum chamber cover -2-.

-- Remove the securing clips -2- -arrow A-.

Fig 2: Removing Securing Clips
GWWA92-10134Courtesy of AUDI OF AMERICA, LLC
CAUTION:

The cowl panel trim could be damaged.

  • Coat the transition between the windshield and cowl panel trim with some soapy water and carefully pull the cowl panel trim -1- vertically out of the retainer on the windshield -B arrows- beginning at the edge of the window.

-- Remove the cowl panel trim -1- by carefully removing it from the retainer on the windshield -B arrows-.

-- Disconnect the connector -2-.

Fig 3: Disconnect Electrical Connector
GWWA92-10146Courtesy of AUDI OF AMERICA, LLC

-- Remove the drain channel -3- on the linkage -arrows A-.

-- Remove the bolts -4, 5 and 6-.

-- Rotate the wiper arm frame -1- with the linkage and wiper motor upward -arrow B- and pull it forward out of the plenum chamber.

scientia non olet · About LEMON Manuals