Washer Fluid Reservoir Filler Tube, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Filler Neck -1- With Filler Tube From Washer Fluid Reservoir & Body Opening -Arrow-

Courtesy of AUDI OF AMERICA, LLC

Tightening specification, refer to OVERVIEW - WINDSHIELD WASHER SYSTEM .

Install in reverse order of removal. Note the following:

-- Slide the sealing grommet -2- on the filler neck tube -1- as far as the stop.

The tab -3- must fit into the opening -arrow- on the filler tube.

-- Slide the filler neck into the washer fluid reservoir.

NOTE:

Make sure the O-ring is not crushed when sliding it into the washer fluid reservoir.