Right Engine Mount, Removing And Installing: Removing

Fig 1: Identifying Engine Covers

Courtesy of AUDI OF AMERICA, LLC

-- Remove the rear engine cover in direction of -top arrows-.

-- Position the Engine Support Bridge 10-222A on the left and right suspension strut towers as illustrated.

Fig 2: Positioning Engine Support Bridge On Left And Right Suspension Strut Towers

Courtesy of AUDI OF AMERICA, LLC

-- Attach the Engine Support Bridge - Spindle10-222A/11 to the right engine lifting eye and pretension the engine slightly.

-- Remove the right front wheel.

-- Remove the right front wheel housing liner, refer to WHEEL HOUSING LINER .

-- Remove the noise insulation -1 and 2-, refer to OVERVIEW - NOISE INSULATION .

Fig 3: Identifying Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -1- and remove the bracket with the wiring harness from the subframe.

Fig 4: Identifying Nut And Bracket With Wiring Harness From Subframe

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1, 2 and 4- and move the right engine mount retaining plate -3- to the side.

Fig 5: Identifying Bolts And Right Engine Mount Retaining Plate

Courtesy of AUDI OF AMERICA, LLC

-- Remove bolt -arrow- on ATF line bracket.

Fig 6: Identifying ATF Line Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Lift the engine using the Engine Support Bridge - Spindle10-222A/11 to dimension -a-.

Fig 7: Raising Engine To Dimension -A- Using Spindle 10-222A /11

Courtesy of AUDI OF AMERICA, LLC

• Dimension -a- = approximately 20 mm.

-- Remove the right engine mount.