Seat Belt Webbing, Checking

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Procedure

-- Pull the belt completely out of the automatic belt retractor or lap belt adjustment tongue.

-- Check belt webbing for soiling, wash with mild soap solution if necessary. Refer to the Operating Instructions.

If one of the types of damage (1 and 2) shown in the following is detected on a vehicle which has been in an accident - seat belt must be replaced completely with belt buckle.
If damage as illustrated under points 1, 2 or 3 is determined on vehicle which has not been involved in an accident, it is sufficient to replace damaged belt only.
1 - Belt webbing cut, torn or chafed.

Fig 1: Belt Webbing Cut, Torn Or Chafed
Courtesy of AUDI OF AMERICA, LLC
2 - Webbing loops on belt edge torn.

Fig 2: Checking Belt Webbing - Webbing Loops On Belt Edge Torn
Courtesy of AUDI OF AMERICA, LLC
3 - Burn marks from cigarettes or the like.

Fig 3: Burn Marks From Cigarettes Or Similar
Courtesy of AUDI OF AMERICA, LLC