Impact Absorber, Removing And Installing, Vehicles Through My 2012: Removing
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Cable Tie -1-, Bumper Cover Spacer -2-, Electrical Wiring Harness -3-, Electrical Connector -4- & Impact Bar -5-
NOTE:
During installation, all cable ties must be installed at the same location.
-- Remove the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .
-- Disconnect the electrical connector -4- on the horns and free up the electrical wiring harness -3- on the horn bracket.
-- Free up the washer nozzle water drain hose by disconnecting the cable tie -1-.
-- Remove the bolts -arrows- and the bumper cover spacer -2-.
-- Remove the impact bar -5- from the mounts.