LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 644 (3.0L - Diesel Fuel Injection - Engine Code(S): CPNB (As Of 07.2014)) >> 23 Diesel Fuel Injection >> Sensors >> Fuel Pressure Sensor -G247-, REMOVING AND INSTALLING >> Installing

Fuel Pressure Sensor -G247-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

A Fuel Pressure Sensor -G247- with an undamaged biting edge and thread can be reused one time.

Check the new Fuel Pressure Sensor -G247- for damage to biting edge and thread.

Check the sealing surface on the hole inside the fuel rail.

Coat the Fuel Pressure Sensor -G247- thread and biting edge with diesel fuel.

-- Tighten the Fuel Pressure Sensor -G247- by hand.

-- Then tighten the Fuel Pressure Sensor -G247- to the specification.

-- Perform a leak test on the fuel system, refer to FUEL SYSTEM LEAK TEST .

scientia non olet · About LEMON Manuals