LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 644 (3.0L - Diesel Fuel Injection - Engine Code(S): CPNB (As Of 07.2014)) >> 23 Diesel Fuel Injection >> Sensors >> Differential Pressure Sensor -G505-, REMOVING AND INSTALLING >> Installing

Differential Pressure Sensor -G505-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Blow through the hose in the direction of the particulate filter with compressed air to remove any plugs or ice-ups due to condensation water.

Make sure the hoses are secure and sealed.

If the particulate filter pressure lines were removed, tighten them to the tightening specification.

Secure all hose connections with hose clamps of the same type as those equipped by the factory .

An adaptation must be performed after replacing the Differential Pressure Sensor -G505- and/or particulate filter. Use a Vehicle Diagnostic Tester.

scientia non olet · About LEMON Manuals