Overview - Intake Manifold
WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Bracket
- For the air guide pipe
- Bolt
- Tightening specification: 9 Nm
- Bolt
- Tightening specification: 9 Nm
- Seal
- Check and replace if damaged
- Bolt
- Tightening specification: 9 Nm
- Bolt
- Tightening specification: 9 Nm
- Intake Flap Motor -V157-
- Removing and installing, refer to Intake Flap Motor -V157-, REMOVING AND INSTALLING .
- Seal
- Check and replace if damaged
- Intake Manifold
- Removing and installing, refer to INTAKE MANIFOLD, REMOVING AND INSTALLING .
- Bolt
- Tightening specification and sequence, refer to Fig 2.
- Mounting Pins
- Tightening specification: 5 Nm
- For engine cover
- Bracket
- For the connector
- Bolt
- Tightening specification: 4 Nm
- Wiring Guide
- Bolt
- Tightening specification: 4 Nm
- Seals
- Replace
- Bracket
- For the EGR Cooler Switch-Over Valve -N345-
- Bolt
- Tightening specification: 9 Nm
- Mounting Pins
- Tightening specification: 5 Nm
- For engine cover
- Air guide pipe
- Bolt
- Tightening specification: 9 Nm
- Seal
- Replace
- Hose clamp
- Tightening specification, refer to Fig 3.
- Air Guide Hose
- Throttle Valve Control Module -J338-
- Removing and installing, refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .
- Seal
- Replace
- Pipe
- For the exhaust gas recirculation
- Bolt
- Tightening specification: 9 Nm
- Pipe
- For the exhaust gas recirculation
- Seal
- Replace
- Hose clamp
- Tightening specification and sequence, refer to Fig 4.
-- Tighten the bolts in 3 steps as follows:
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1. | -1 through 4-, -arrows- | Install all the way in by hand. |
| 2. | -1 through 4- | 5 Nm in sequence shown |
| 3. | -1 through 4- and -arrows- | 9 Nm in any sequence |