Overview - Heated Oxygen Sensor, Vehicles With Engine Code CDUD
WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Pressure Pipe
- for the Differential Pressure Sensor -G505-
- Tightening specification: 45 Nm
- Heated Oxygen Sensor -G39- with Oxygen Sensor Heater -Z19-
- Coat new oxygen sensors with an assembly paste
- Only the thread may be coated with hot bolt paste on a used oxygen sensor .
- Assembly paste or hot bolt paste must not enter the slots on the sensor body.
- Tightening specification: 55 Nm
- Removing and installing, refer to Heated Oxygen Sensor -G39-, REMOVING AND INSTALLING, VEHICLES WITH ENGINE CODE CDUD .
- Exhaust Gas Temperature Sensor 3 -G495- connector
- Heated Oxygen Sensor -G39- connector
- Exhaust Gas Temperature Sensor 1 -G235- connector
- Differential Pressure Sensor -G505-
- Removing and installing, refer to Differential Pressure Sensor -G505-, REMOVING AND INSTALLING .
- Tightening specification: 4.5 Nm
- Exhaust Gas Temperature Sensor 4 -G648-
- Removing and installing, refer to Exhaust Gas Temperature Sensor 4 -G648-, REMOVING AND INSTALLING .
- Exhaust Gas Temperature Sensor 1 -G235-
- Removing and installing, refer to Exhaust Gas Temperature Sensor 1 -G235-, REMOVING AND INSTALLING .
- Exhaust Gas Temperature Sensor 3 -G495-
- Removing and installing, refer to Exhaust Gas Temperature Sensor 3 -G495-, REMOVING AND INSTALLING .