Fuel Pressure Regulator Valve -N276-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the engine cover.
WARNING:
Danger of malfunction caused by dirt.
-- Clean and dry off the threaded area around the fuel pressure regulator valve with engine or brake cleaner.
NOTE:
Clean carefully, cleaner must not enter the connector.
Dirt must not get into the fuel rail boring.
-- Remove the fuel supply hose banjo bolt.
-- Disconnect the connector -arrow- from the Fuel Pressure Regulator Valve -N276-.
-- Counterhold fuel rail and loosen union nut on regulator valve. Then remove by hand.
-- Clean off dirt from fuel rail threading and sealing surfaces. Do not use mechanical tools.
NOTE:
Seal the hole in the fuel rail immediately with a plug to prevent dirt from entering.