LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 643 (3.0L - Diesel Fuel Injection - Engine Code(S): CPNB (As Of 05.2013)) >> 23 Diesel Fuel Injection >> Removal And Installation >> Engine Control Module -J623-, REMOVING AND INSTALLING >> Installing

Engine Control Module -J623-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal.

-- Thereafter, the Engine Control Module -J623- must be equipped with the protective housing.

-- Clean threaded holes for shear bolts of locking compound residue. Cleaning can be performed with a thread cutter (tap).

-- Always use new shear bolts.

The procedures to follow after connecting the new ECM are described in Guided Fault Finding and Guided Functions. Use a Vehicle Diagnostic Tester.

scientia non olet · About LEMON Manuals