Coolant Recirculation Pump -V50-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

-- Remove the engine cover, refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove the rear noise insulation -2-, refer to OVERVIEW - NOISE INSULATION .

-- Disconnect the connector -2-.

Fig 2: Removing/Installing Coolant Recirculation Pump

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows-.

NOTE:

Use a cloth to catch any leaking coolant.

-- Loosen the hose clamps -1-, then clamp off the coolant hoses with the Hose Clamps - Up To 25mm 3094 and remove them.

-- Remove the Coolant Recirculation Pump -V50-.