LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 639 (3.2L - Crankshaft & Cylinder Block - Engine Code(S): CALB) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Ribbed Belt, Removing And Installing >> Removing

Ribbed Belt, Removing And Installing: Removing

WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Noise Insulation
GWWA10-11100Courtesy of AUDI OF AMERICA, LLC

-- Remove the front noise insulation -1-, refer to FRONT NOISE INSULATION .

Fig 2: Releasing Tension On Ribbed Belt
GWWA13-10098Courtesy of AUDI OF AMERICA, LLC
CAUTION:

Risk of damage due to reversed running direction on a used ribbed belt.

  • Before removing ribbed belt, marking running direction with chalk or felt-tip pen for reinstallation later.

-- Pivot the tensioner clockwise -arrow- to release the tension on the ribbed belt.

-- Remove ribbed belt and release tensioning device.

scientia non olet · About LEMON Manuals